EasyManuals Logo

Juniper EX4500 Series User Manual

Juniper EX4500 Series
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
Chapter 11
Performing Initial Configuration
EX4500 Default Configuration on page 101
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 107
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 109
EX4500 Default Configuration
Each EX Series switch is programmed with a factory default configuration that
contains the values set for each configuration parameter when a switch is shipped.
The default configuration file sets values for system parameters such as syslog and
commit, configures Ethernet switching on all interfaces, enables IGMP snooping, and
enables the LLDP and RSTP protocols.
NOTE: Interfaces xe-0/0/0 through xe-0/0/39 are the network interface ports.
Optional uplink modules provide four 10-gigabit small form-factor pluggable (SFP+)
transceivers (xe-0/1/0 through xe-0/1/3) or four 1-gigabit small form-factor pluggable
(SFP) transceivers (xe-0/2/0 through xe-0/2/3). Although you can install only one
uplink module, the interfaces for both are shown below.
When you commit changes to the configuration, a new configuration file is created,
which becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series
Switch.
This topic shows the factory default configuration file of an EX4500 switch:
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
EX4500 Default Configuration 101

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX4500 Series and is the answer not in the manual?

Juniper EX4500 Series Specifications

General IconGeneral
BrandJuniper
ModelEX4500 Series
CategorySwitch
LanguageEnglish

Related product manuals