Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10 degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related Topics ■ General Safety Guidelines and Warnings for EX Series Switches on page 145
■ Laser and LED Safety Guidelines and Warnings for EX Series Switches on page 151
■ Installation Instructions Warning for EX Series Switches on page 157
■ Grounded Equipment Warning for EX Series Switches on page 163
Rack-Mounting and Cabinet-Mounting Warnings for EX Series Switches
Ensure that the rack or cabinet in which the EX Series switch is installed is evenly
and securely supported. Uneven mechanical loading could lead to a hazardous
condition.
WARNING: To prevent bodily injury when mounting or servicing the switch in a rack,
take the following precautions to ensure that the system remains stable. The following
directives help maintain your safety:
■ The switch must be installed in a rack that is secured to the building structure.
■ The switch should be mounted at the bottom of the rack if it is the only unit in
the rack.
■ When mounting the switch on a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
■ If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the switch in the rack.
Rack-Mounting and Cabinet-Mounting Warnings for EX Series Switches ■ 159
Chapter 18: Installation and Maintenance Safety Information
To Next Page
Loading...
Need help?
General