Juniper EX4500 Series

■ EN 61000-4-4 EFT
■ EN 61000-4-5 Surge
■ EN 61000-4-6 Low Frequency Common Immunity
■ EN 61000-4-11 Voltage Dips and Sags
Related Topics Compliance Statements for EMC Requirements for EX Series Switches on page 184■
■ Compliance Statements for Acoustic Noise for EX Series Switches on page 187
Compliance Statements for EMC Requirements for EX Series Switches
This topic describes the EMC requirements for EX Series switches for:
■ Canada on page 184
■ European Community on page 185
■ Japan on page 185
■ United States on page 185
■ FCC Part 15 Statement on page 185
■ Non-Regulatory Environmental Standards on page 186
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective, operational,
and safety requirements. Industry Canada does not guarantee the equipment will
operate to the users’ satisfaction.
Before installing this equipment, users should ensure that it is permissible to connect
the equipment to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In some
cases, the inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly. The customer should be aware
that compliance with the above conditions may not prevent degradation of service
in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
184 ■ Compliance Statements for EMC Requirements for EX Series Switches
Complete Hardware Guide for EX4500 Ethernet Switches