Juniper PTX10008 - Install the Mounting Hardware

JNP10K-PWR-DC Power Specifications | 180
JNP10K-PWR-DC2 Power Specifications | 181
PTX10000 Grounding Cable and Lug Specifications | 182
PTX10000 Transceiver and Cable Specifications | 184
PTX10000 Optical Transceiver and Cable Support | 184
PTX10000 Cable Specifications for Console and Management Connections | 185
Understanding PTX10000 Series Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion | 186
Signal Loss in Multimode and Single-Mode Fiber-Optic Cables | 186
Attenuation and Dispersion in Fiber-Optic Cable | 187
Calculating the Fiber-Optic Cable Power Budget for a PTX10000 Router | 187
Calculating the Fiber-Optic Cable Power Margin for a PTX10000 Router | 188
PTX10000 Console and Management Cable Specifications and Pinouts | 190
Console Port Connector Pinouts for a PTX10000 | 190
USB Port Specifications for the PTX10000 Series | 191
Management Port Connector Pinouts for the PTX10000 Router | 192
Initial Installation and Configuration
3
PTX10008 Installation Overview | 197
Unpacking the PTX10008 | 198
Unpacking the PTX10008 | 198
Unpacking PTX10000 Line Cards, Routing Control Boards, and Switch Interface Boards | 200
Comparing the PTX10000 Order to the Pack | 202
Installing the Mounting Hardware for a PTX10000 | 206
Installing the PTX10008 into a Rack | 209
Mounting a PTX10008 in a 4-Post Rack Using a Mechanical Lift | 209
Manually Mounting a PTX10008 in a 4-Post Rack | 212
Installing the Front Panel on a PTX10000 | 217
Connecting the PTX10000 to Power | 231
Connecting Earth Ground to a PTX10000 | 232
Connecting AC Power to a PTX10000 | 235
Connecting DC Power to a PTX10000 | 235
vii