Configuring SSR Software on the SSR120
IN THIS SECTION
Configure the SSR120 Appliance from the SSR Conductor | 40
QuickStart From the OTP ISO | 43
The SSR120 appliances are configured from an existing Session Smart Router (SSR) Conductor.
Configure the SSR120 Appliance from the SSR Conductor
The SSR Conductor is an instance that is used to manage the appliances you configure within the same
Authority. It offers centralized administration, provisioning, monitoring, analytics, and lifecycle management
of the appliances.
The Authority is where system-wide data is stored. Conceptually, the Authority represents the complete
set of all appliances managed under a single organizational entity
Using the SSR Conductor, the following procedures guide you through SSR120 appliance configuration.
The names and IP addresses used here are for example only.
Create the SSR Appliance
1. Log in to the Conductor GUI.
2. Select Configuration.
3. In the Routers list, select ADD.
4. Name the new SSR appliance _dallasbr2_ and select SAVE.
•
Input the location _Coordinates_: +32.7767-096.7970/.
•
Select internal for Inter-node Security Policy.
40
To Next Page
Loading...
Need help?
General
