Appendix A: Group Simultaneous Pulse Feature
Page 73 © JVA Technologies www.jva-fence.com
We recommend following these steps in the right order:
1. Disarm all energizers in the group. If energizers are not disarmed
Step10 may not work correctly.
2. Program the keypad address using one of the energizers.
3.
Slave 1 address=2...).
4. Connect any control/monitoring unit 12V, GND and Data to the Group
Master
5. Connect all the slaves Data and GND to the Group Master.
6.
arm.
7.
8. Wait 5 minutes for all the Energizers to synchronise with the Master
9.
-
pads to be recognised by all energizers in the group.
10.
the group and check what energizers are connected.
11. Arm the group using keypad 1, 2, 3, 4, *, 1, 0, #, or by using Perimeter
Note:
1.
2. A slave will generate a General alarm if the keypad bus is broken be-
tween it and the group master.
3.
4.
Patrol interface.
5. A Keypad that is connected to a Slave Energizer that is disconnected
To Next Page
Loading...
