Safety and Responsibility
3 --- 12
3 Safety and Responsibility
Disregard of these instructions can result in serious injury.
Read the service manual carefully and take notice of the contents for
safe machine operation.
The machine is manufactured to the latest engineering standards and acknowledged
safety regulations. Nevertheless, the dangers can arise by its operation:
Danger to life and limb of the operator or third parties
Detrimental to the machine and property.
Use this machine only if it is in a technically perfect condition and only for the purpose
for which it is intended, observing all safety measures and the instructions in the ser-
vice manual.
In particular, immediately rectify (have rectified) any faults that could be detrimental to
safety.
3.1 Specified Use
The machine is intended solely for industrial use in generating compressed air. Any
other use is considered incorrect. The manufacturer is not liable for any damages re-
sulting from such unspecified use or application. The risk involved in such unspecified
use is taken solely by the user.
Specified use also includes compliance with the instructions in this manual.
Operate the machine only within its performance limits and under the permitted ambi-
ent conditions.
3.2 Unspecified Use
Never direct compressed air at persons or animals.
Do not use untreated compressed air for breathing purposes.
Do not use untreated compressed for any application that will bring it into direct con-
tact with foodstuffs.
Cooling air, warmed after passing through the machine, may be used for heating pur-
poses but only when it poses no health risk to humans or animals. If necessary, the
warmed cooling air should be treated to render it harmless.
Do not allow the machine to take in toxic, acidic, flammable of explosive gases or va-
pours.
Do not operate the machine in areas in which specific requirements with regard to ex-
plosion protection are applied.
3.3 User’s Responsibilities
Observe statutory and accepted regulations
Observe relevant statutory and accepted regulations during installation, operation and
maintenance of the machine.
For example, nationally applied European directives and/or valid national legislation, safety
and accident prevention regulations.
3.3.1 Qualified personnel
Ensure that operating, installation and maintenance personnel are qualified and authorised
for their tasks.
DANGER
To Next Page
Loading...
Need help?
General
