Operation
8 --- 42
8.3 Remote On and Off Switching
Pre---condition: A remote control device is connected.
Apply the remote warning label to the machine where it is plainly visible.
BEWARE! This machine is remotely controlled and can start at any
time.
Label the remote control device accordingly:
”Before starting, make sure that no one is working on the machine and
it can be safely started.”
Press the ’Remote’ key (5).
The LED lights. The remote control device has control of the machine.
The machine can still be switched on and off by the ’ON’ and ’OFF’ keys (2 and 3) if re-
quired.
8.4 Switching On and Off with the Clock
Pre---condition: The clock is programmed.
Apply the time---controlled warning label to the machine where it is plainly
visible.
”BEWARE! This machine is clock---controlled and can start at any
time.”
Press the ’Clock’ key (4).
The LED lights. The integrated clock has control of the machine.
8.5 Acknowledging and Resetting Warning and Alarm Messages
Fig. 19 Acknowledging and resetting warning and alarm messages
10 ’Warning’ LED (yellow)
11 ’Alarm’ LED (red)
12 ’Acknowledge’ (reset) key
To Next Page
Loading...
