What to do if info code REVERSE flashes on Kamstrup Measuring Instruments display?
If the info code REVERSE is flashing on the display, it means the meter is installed with water flowing in the wrong direction. To resolve this, ensure the meter is mounted according to the flow arrow located on the side of the meter case.
Why does info code DRY flash on Kamstrup flowIQ 3100 display?
If the info code DRY is flashing on the display, it indicates that the meter is not water-filled. Air the installation to resolve this. The info code will disappear once the meter is filled with water.
What to do if info code REVERSE flashes on Kamstrup flowIQ 3100 Measuring Instruments?
If the info code REVERSE is flashing, it means the meter is installed with water flowing in the wrong direction. Remount the meter following the flow arrow located on the side of the meter case.
Why does info code DRY flash on Kamstrup flowIQ 3100 Measuring Instruments?
The info code DRY flashes because the meter is not water-filled. To resolve this, air the installation. The info code will disappear once the meter is filled with water.
Why does info code RADIO OFF flash on Kamstrup Measuring Instruments?
The info code RADIO OFF flashes because the meter is still in transport mode with the built-in radio transmitter turned off. This info code disappears, and the radio switches on, after the first ½ liter of water has run through the meter.
How to fix no display function (empty display) on Kamstrup Measuring Instruments?
If there is no display function (empty display), it means the battery needs to be replaced. Send the meter to Kamstrup A/S for a battery replacement.
General| Type | Ultrasonic water meter |
|---|---|
| Application | Residential and commercial water metering |
| Battery Life | Up to 16 years |
| Pressure rating | PN16 |
| Protection Class | IP68 |
| Sizes | DN15, DN20, DN25, DN40 |
| Measuring range | 0.015 m³/h to 6 m³/h |
| Communication | Wireless M-Bus, Wired M-Bus |
| Power supply | Battery |
| Temperature range | 0.1°C to +50°C |
| Approval | MID approved |
| Measurement principle | Ultrasonic |
| Flow rate range | 0.015 m³/h to 6 m³/h |
| Pipe diameter range | DN15, DN20, DN25, DN40 |
| Material | Brass |
To Next Page
