Page 49
ELECTROMAGNETIC COMPATIBILITY
European Council Directive 89/336/EEC requires electronic equipment not to generate
electromagnetic disturbances exceeding defined levels and have adequate immunity
levels for normal operation. Specific standards applicable to this analyser are stated
below.
As there are electrical products in use pre-dating this Directive, they may emit excess
electromagnetic radiation levels and, occasionally, it may be appropriate to check the
analyser before use by:
Use the normal start up sequence in the location where the analyser will be
used.
Switch on all localized electrical equipment capable of causing interference.
Check all readings are as expected. A level of disturbance is acceptable.
If not acceptable, adjust the analyser’s position to minimize interference or
switch off, if possible, the offending equipment during your test.
At the time of writing this manual (February 2013) Kane International Ltd are not aware
of any field based situation where such interference has occurred and this advice is
only given to satisfy the requirements of the Directive.
This product has been tested for compliance
with the following generic standards:
EN 61000-6-3 : 2011
EN 61000-6-1 : 2007
and is certified to be compliant
Specification EC/EMC/KI/KANE457 details
the specific test configuration, performance
and conditions of use.
END OF LIFE DISPOSAL
The Waste Electrical or Electronic Equipment (WEEE) Directive requires countries in
the EU to maximize collection and environmentally responsible processing of these
items.
Products are now labelled with a crossed out wheeled bin symbol to remind you that
they can be recycled.
Please Note: Batteries used in this instrument should be disposed of in accordance
with current legislation and local guidelines.
To Next Page
Loading...
Need help?
General
