28
The physical properties of the sensor require quantization of the exposure time to a time
pattern. As a result, the accuracy with which the desired exposure time can be set is limited.
“Reset / Restart”
The exposure of the sensor is started by an external trigger signal or a software trigger command. The
duration of the exposure time can be transferred using the appropriate commands.
The chronological sequence of exposure and readout time is as follows:
Figure 4-13 Chronological Sequence of Exposure and Readout Time in the exposure Mode
“Reset /Restart”
The exposure time is started by the trigger signal. The duration of the exposure time must be set with the
appropriate command. At the end of the exposure time, the readout time starts for the image to be
captured.
Software-Reset
The FE320 cameras can be restarted by calling the appropriate commands. Here all hardware components
and control circuits are initialized.
To Next Page
Loading...