Kappa Flight Eye FE320 - 6 Initial Operation; Precautions; Recommended Hardware for the Camera Operation; Table 6-1 Recommended Hardware for the Camera Operation

30
6 Initial Operation
Precautions
Make sure that you observe the following precautions:
1. The protection-class (IP67) is only given if the recommended smart wire (Refer to chapter 6.2) between
the CSU and CEU is installed or if the CSU and CEU are directly connected to each other.
2. While the CSU and CEU is operating in ambient conditions of about 25°C the housings reaches
temperatures of around 50°C. In this case handle the CSU and CEU with care.
Recomm ended Hardware for the Camera Operation
Kappa recommends using the following mating plugs and cables to ensure optimum performance of the
camera:
Equivalent alternatives can be used for items listed below.
No.
Camera
Order-No. from Vendor
1
Mating set power-connector
Kappa PN: 920-0004
Power cable (recommended)
Kappa PN: 922-0287
2
Mating set communication (recommended)
Kappa PN: 920-0003
Cable (recommended)
Kappa PN: 922-0286
Table 6-1 Recommended Hardware for the Camera Operation