KATEK Steca coolcept fleX - EU Declaration of Conformity; 2 Abbreviations; 3 Safety; Designated Use

EN
6 762.885 Z05 2012 coolcept_fleX, coolcept³_fleX
1.6 EU Declaration of Conformity
The products described in this document comply with the applicable European directives.
The certificate is available in the download area of our homepage.
2 Abbreviations
Abbreviation
Description
AC Alternating Current
DC Direct Current
LAN
L
ocal
A
rea
N
etwork
MPP
M
aximum
P
ower
P
oint
MPP tracker Regulates the power of the connected module strings to the MPP
PV
P
hoto
v
oltaics (technology for the conversion of solar energy into
electrical energy)
RTU
R
emote
T
erminal
U
nit
SELV Safety Extra Low Voltage
TCP/IP Transmission Control Protocol/Internet Protocol
3 Safety
3.1 Designated use
The coolcept fleX inverters are intended for single-phase and the coolcept³ fleX inverters
for three-phase feed-in and are suitable for indoor and outdoor installation on a wall.
Only use the inverter:
• for grid-connected PV generators.
• for PV generators whose connections are not grounded.
• for solar modules with Class A rating in accordance with IEC 61730 because the in-
verter does not have any galvanic isolation.
• when the maximum permissible system voltage of the PV generator is higher than the
AC grid voltage.
NOTE
Only for Australia: the inverter may only be operated as a single device. It is
not permitted to interconnect several devices.
NOTE
Only for Italy: information about the particularities for the use in Italy have
been added as an appendix to the Italian version of these instructions.