KBL 3500 - Page 36

Operating Instructions KBL 3500
36
The bed pane has to be cleaned when necessary. The
cleaning and care instructions have to be observed. The outer
surface can be cleaned without any preparatory works. In the
following, we describe how to clean the inner surface.
The electronic components under the bed may not be subjected to
humidity. You should therefore use a slightly damp cloth only to clean
the inner surface of the bed pane and the interior of the bed section.
Fold up the canopy of the sunbed.
Undo the 2 fl at-head screws on the left-hand and on the right-hand side
of the bed pane.
Lift the pane so that you are able to take out one of the pane holders
located behind the front edge. Lift the pane further and erect the pane
holder beyond the resistance point so that the rod stays in the fi tting.
Repeat this procedure for the second pane holder so that the pane rests
on both holders.
Clean the inner surface of the bed pane. Pay attention
to the pane holders during cleaning.
As soon as the inner surface of the bed pane is
completely dry, fold it down and re-fasten it.
Clean the outer surface.
1.
2.
3.
4.
5.
6.
Cleaning the
bed pane
Cleaning the
bed pane