KEB COMBIVERT F5 BASIC - Page 151

Functional Description
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM
6.12 Technology Control
6.13 CP-Parameter Definition
6
41
KEB COMBIVERT F5-G / B
Name: Basis
06.02.02
© KEB Antriebstechnik, 2002
All rights reserved
Section PageDate Chapter
6.4.1 Summary Description ............. 3
6.4.2 Setpoint Selection .................. 4
6.4.3 Rotation Selection .................. 6
6.4.4 Fixed Frequencies .................. 9
6.4.5 Setpoint Limits ..................... 11
6.4.6 Setpoint Computation ........... 12
6.4.7 Ramp Generator ................... 13
6.4.8 Limiter................................... 15
6.4.9 Ramp with constant time ...... 15
6.4.10 Used Parameters .................. 18