KEB COMBIVERT G6 - Repair and Disposal

GB - 20
Parameter Description
3. Parameter Description
On delivery the KEB COMBIVERT G6 is assigned with an user menu, the customer parame-
ters (CP-Parameters). These represent a selection of important parameters for the operation.
Up to a maximum of 48 customer parameters can be dened from over 500 parameters.
Only parameter CP00 password input is predened and can not be modied or deleted.
Depending on the unit, there are three different customer parameter menus:
• for open-loop operation 00G6N1B-C000
• for ASCL operation 00G6N1B-H000
• for SCL operation 00G6N1B-J000
The menu to be used can be determined from parameter CP48 (see below).
CP48 Software version
Co-domain Setting Description
0.0.0.0 … F.F.F.F – Display of the software version
The rst two digits display the major and minor version number (e. g.
1.2.x.x → V1.2)
The third digit displays the power unit software (open-loop, ASCL, SCL).
Depending therefrom there are different customer parameter menu im-
plemented. The corresponding instruction manuals are shown in the fol-
lowing table.
Power unit software
Instruction manual
Material Number
x.x.0.x Power unit open-loop 1st version 00G6N1B-C000
x.x.1.x Power unit open-loop 2nd ver-
sion
00G6N1B-C000
x.x.2.x Power unit ASCL 00G6N1B-H000
x.x.3.x Power unit SCL 00G6N1B-J000
The fourth digit displays a serial number for the date code.
The instruction manuals are also available for download on our homepage.