Handheld Terminal Options
User's Manual, version: 3.1 / material no.: 57448 107
© KEBA 2006
9 Options
This chapter describes the options the KeTop is available with.
Override Potentiometer
If available, the override potentiometer in the KeTop is evaluated by the
software and can be read via the KeTop-API using a program.
The override potentiometer can be used for example for setting the number
of spindle revolutions and the forward feed on machine tools.
z Resolution: 0 – 127, linear
Electronic Handwheel
If available, the electronic handwheel in the KeTop is evaluated by the
software and can be read via the KeTop-API using a program.
50 pulses are counted per revolution. Turning the handwheel clockwise in-
crements the count, turning the handwheel counter-clockwise decrements
the count (-32768 to +32767, 16-bit value).
Main features
z 50 lock-in positions / revolution
z 1 pulse / lock-in position
z
Notice
• If the KeTop falls to ground, control the position of the handwheel knob.
If necessary press down the knob until it snaps in.
To Next Page
Loading...