Options KeTop T100
108 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Illuminated Push-Button
If available, the illuminated push-buttons in the KeTop are evaluated by the
software and can be read via the KeTop-API (see page
49) using a pro-
gram.
The illuminated push-buttons are available as „momentary“ type (labeled 0
or I) or as „maintaining“ type (labeled 0/I).
WARNING
!
• After removing the covers of the push-buttons (in case of changing the labelling)
take care that the labelling plates are positioned again correctly refering to the
functionality of the push buttons.
(Otherwise the wrong push-button may be used for switching ON or OFF the
motor.)
Key Switch
If available, the key switch is evaluated by the software in the KeTop and
can be read via the KeTop-API using a program.
The key switch is available with 3 positions labeled „I-0-II“ or „0-I-II“.
Selector Switch
If available, the selector switch is evaluated by the software in the KeTop
and can be read via the KeTop-API using a program.
The selector switch is available with 3 positions labeled „I-0-II“ or „0-I-II“.
Joystick
If available, the 2-axis joystick in the KeTop is evaluated by the software
and can be read via the KeTop-API using a program.
To avoid that the joystick is damaged when the device falls to ground, a
short joystick is used. The joystick enables moving robot axes for example.
z Value range: -15 to +15 per axis (31 increments)
In the KeTop there is only space for the optionally 3-axis joystick or
a flash
card slot.
To Next Page
Loading...