Connection KeTop T100
30 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Ethernet
The standard version of the KeTop is equipped with an Ethernet interface.
This interface is based on the 10BaseT specification and suitable for the
half-duplex mode.
The data communication for these interfaces takes place via the Ethernet
connector S4 in the cable entrance area of the KeTop.
The following interface parameters are defined and cannot be changed:
z 10 Mbaud
z TCP/IP protocol
The Ethernet interface is selected under Windows CE as follows:
Start -> Settings -> Control Panel -> Network and Dial-up Connections:
Here you can select the Ethernet on-board interface SMSC91C9X.
WARNING
!
• If the KeTop and the control do not communicate via a point-to-point connection,
it may happen that the keypad data, for example, are transmitted with a delay.
Therefore it is advisable to establish the connection between the control and
the KeTop only via an Ethernet switch which enables a point-to-point connec-
tion.
If an Ethernet PC card is inserted into the PC card slot, the internal
Ethernet interface must be deactivated.
The selection between the internal Ethernet or the PC card Ethernet inter-
face is made in the „ConfigTool“. See chapter „
KeTop Configuration Tool
(ConfigTool“ on page
96).
The positions of the Dip switches in the cable entrance area are not rele-
vant for this interface.
To Next Page
Loading...