Keba KeTop T100 - Remote Software Activesync

Software KeTop T100
90 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Remote Software ActiveSync
This software is used as a debug interface and to adjust and transmit data
from and to a PC.
The remote software ActiveSync is a product by Microsoft and can be
downloaded free of charge from the following download address:
http://www.microsoft.com/windowsmobile//downloads/activesync38.mspx
The data connection from the KeTop to the PC is established as follows:
► 1. Remove the cover of the cable entrance area on the KeTop.
► 2. Plug in the Download Cable KeTop XD 040
► 3. Start the ActiveSync software on the PC
a) select 'File' -> 'Delete Partnership' ...
b) deactivate '( ) Allow serial cable or ... ' -> <OK>
c) activate '(x) Allow serial cable or ... ' -> <OK>
► 4. Start the ActiveSync-Software on the KeTop:
Start -> Programs -> Communication -> Active Sync
► 5. At the PC:
- Connect KeTop as a "Guest' (Set Up a Partnership -> No).
Now the data connection between the KeTop and the PC is established. In
case of communication problems, check the following conditions:
z Max. time delay between step 3c) and step 4. = 30s.
z For further attempts repeat steps 3. to 5.
z The ActiveSync software must be started manually.
(Plugging in the connection cable does not start ActiveSync!)
z The factory-set baudrate for the remote connection is 115 kBaud.
In case of communication problems the baudrate can be reduced.
The baudrate can be changed as follows:
- Start -> Programs -> Communication -> Remote Networking
- select "com1_115k"
- File -> Properties
- SP1 on COM1: -> Configure -> Port Setttings
(...change Baud Rate...)
- Close all Windows with <OK>
(optional: Start -> Programs -> KeTop -> Registry Backup -> <OK>)