Connection KeTop T100
34 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Serial port female connector S2 for Debug Interface (RS-232-C)
Using the „Boot-Loader“ software, the „serial port“ interface can be used for
debugging and for downloading software. Using the remote software Ac-
tiveSync, it can be used for adjusting and transmitting data from and to a
PC.
For that purpose, the download cable KeTop XD040 is available.
The following interface parameters are defined and cannot be changed:
z 38400 baud
z 8 data bits
z 1 stop bit
z No parity
z No handshake
The debug interface is assigned to the COM 1 interface port in the soft-
ware.
The positions of the Dip switches in the cable entrance area are not rele-
vant for this interface.
To Next Page
Loading...