KeTop - Specific Operating Instructions KeTop T100
104 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Installation of Programs
Programs can be only installed in the IPSM (Intel Persistent Storage Man-
ager) directory. Since only this directory is stored in the flash, data installed
in another way will get lost after turning off the KeTop.
Installation data entered in the registry can be saved with the command
„\Windwos\Regflush.exe“.
Notice
• System files, which are copied to the directory \windows while
installation, do not remain durably stored. For this reason these files
must be copied manually into the directory \IPSM\windows (if
necessary, this directory must be created by the user). With a restart of
Windows CE these files are copied automatically into the directory
\windows. So, these files are again available for the operating system
and are again present also after a restart (KeTop T100: valid from
OEM Build Vers. 1.4a; KeTop T50: valid from OEM Build Vers. 1.2).
Saving Files
Files must be saved in the IPSM directory. The contents of other directories
are not saved when the device is turned off.
Transfering Files
Transfer via external storage device (PC-card, CF-card, USB-Stick)
For further information on suitable storage devices please refer to the sec-
tion "PC-card slot for PC-cards I, II, III" and/or "Compact Flash - Card Slot"
in the chapter "Connection” or “USB-Stick”.
► Insert the external storage device into a suitable PC.
► Copy the required files to the external storage device.
► Insert the external storage device into the KeTop.
► Copy the required files from "\storage card" or “\hard disk” to "\ipsm".
To Next Page
Loading...