General Instructions KeTop T100
14 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
3 General Instructions
Waste disposal
Observe the national regulations when disposing of electronic components!
Handling of KeTop
You have chosen a high-quality KeTop that is equipped with highly sensi-
tive state-of-the-art electronics.
To avoid malfunctions or damage through improper handling, follow these
instructions during operation.
CAUTION
• Turn off the power supply before opening the cable entrance area of the KeTop.
Otherwise the components could be destroyed or undefined signals could oc-
cur.
• Make sure that nobody can fall over the cable to avoid that the device falls to
ground.
• Take care not to squeeze and thus damage the cable with any object.
• Do not lay the cable over sharp edges to avoid damaging the cable sheath.
• If you do not use the device, hang it into the wall bracket KeTop WBxxx provided
for storage.
• Do not lay down the device with the operating side facing down to avoid damag-
ing the operating elements.
• Never lay the device onto unstable surfaces. It could fall to ground and thus be
damaged.
• Never lay the device close to heat sources or into direct sunlight.
• Avoid exposing the device to mechanical vibrations, excessive dust, humidity or
to strong magnetic fields.
• Never clean the device, operating panel and operating elements with solvents,
scouring agent or scrubbing sponges. For cleaning the device, use a soft cloth
and a bit of water or a mild cleaning agent.
• Make sure that no foreign objects or liquids can penetrate into the device. Check
at regular intervals the protective covers of the device, if all housing screws are
firmly tightened and if the housing or the cable entry is damaged.
• If the device shows any defect, please send it, including a detailed error descrip-
tion, to your supplier or the relevant after-sales service office.
To Next Page
Loading...