Connection KeTop T100
16 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
4 Connection
Cable Entrance Area
Ethernet
S4
B5
B4
B2 B6 B3
ON:
OFF:
Serial
port
Reset
Dip switches RS-422-A:
B2 B6 B3
B5
B4
Location of
dip switches:
S6,
COM-Modul
Adhesive label for KeTops
with RS-422-A interface
with location and position of
dip switches for this interface
S19
Blind plug
must be used
to ensure
impermeability!
Adhesive label
for CPU serial number
and Ethernet (MAC)-
address (see below)
Or adhesive label for KeTops
with Ethernet interface
only identification of serial port
and reset button:
Serial
port
Reset
RS-422-A connector
for data exchange
Strain relief
for connecting cable
(on left or right side)
ATTENTION:
Use blind plug on
cable outlet not used.
Main connector
(male)
for power supply and
control lines
Serial port female connector S2
for debug interface (RS-232-C)
for downloading software
and locating errors
Reset button
for rebooting Windows CE.
ATTENTION:
All data not saved get lost.
Ethernet connector
for data exchange
AABBCCDDEEFF
00:60:B5:06:00:01
2250-00001
B5
B2, B3, B4, B6
Dip switches
to select the RS-422-A
interface (for the setting,
see the adhesive label for
KeTops with RS-422-A
interface)
Cable entrance area of KeTop T100
Adhesive label for CPU serial number and Ethernet (MAC)-address
00:60:B5:06:00:01
2250-00001
KeTop-T100 CPU serial number
Ethernet (MAC) address
ID for KEBA
ID for KeTop-T100
KeTop-T100 CPU serial number
(the last five digits, hex-coded)
Adhesive label for CPU serial number and Ethernet-address
To Next Page
Loading...