Handheld Terminal Connection
User's Manual, version: 3.1 / material no.: 57448 17
© KEBA 2006
Cable Routing in Cable Entrance Area
After opening the cable entrance area, the connecting lines can be routed
as described in the following chapters. Before opening the KeTop please
pay attention to the following safety instructions:
Instructions for opening the cable entrance area:
• Lay the KeTop with the display facing down onto a plane and clean ta-
ble (preferable on ESD pad) and take care not to damage the KeTop
and its operating elements.
• For opening and closing the cable entrance area use the following type
of screwdriver: „Phillips size 2“.
Instructions for modifications in the cable entrance area:
• Unplug the main connector (S19) by pulling on its wires with your fin-
gers. Do not use any sharp objects.
• For unplugging the RJ-45 jack (S4 / S6), actuate the locking lever:
S19S19
S4 / S6
1
2
Make sure that the connectors S19 and S6 correctly snap in when you plug
them in. Otherwise the emergency stop functionality (S19) or the correct
shielding (S4/S6) might not be given any more.
Instructions for closing the cable entrance area: Make sure that
• the sealing is clean, not damaged and correctly positioned in the cable
entrance area,
• no cables are squeezed in,
• the cover of the cable entrance area is attached again with all 6 screws
(torque: 0.4 bis 0.5 Nm). Otherwise the protection degree cannot be
guaranteed.
To Next Page
Loading...