Connection KeTop T100
36 User's Manual, version: 3.1 / material no.: 57448
© KEBA 2006
Inserting the PC Card
Lay the KeTop with the display facing down onto a plane and
clean table (preferably on ESD pad) and take care not to
damage the KeTop and its operating elements.
Unlock the PC card cover as shown
(until the locking lever is released).
1) Open the cover.
2) Insert the PC card as shown.
Insert the PC card until it locks in and the ejection
button jumps out.
1
2
1
3
5
2
4
6
ATTENTION:
Take care that this corner
is inserted into the slot on
the side of the ejection
button.
Ejection button
1
2
3
1) Close the cover.
2) and 3) Lock the cover as shown.
Press down the cover until it snaps in completely to meet
the protection degree IP54.
Must snap
in completely!
ATTENTION:
Check the condition
and the position of the
sealing before closing
the PC card cover.
To Next Page
Loading...