Keithley 2001 Calibration Manual

B
Calibration Programs
B-1
Introduction
This appendix includes programs written in QuickBASIC
and Turbo C to aid you in calibrating the Model 2001. Pro-
grams include:
• Comprehensive calibration programs for use with any
suitable calibrator.
• Comprehensive calibration programs for use with the
Fluke 5700A Calibrator.
• Low-level calibration programs for use with the Fluke
5700A Calibrator.
Refer to Section 2 for more details on calibration procedures.
QuickBASIC program requirements
In order to use the QuickBASIC programs, you will need the
following:
• IBM PC, AT, or compatible computer.
• IOtech Personal488, CEC PC-488, or National Instru-
ments PC-II or IIA IEEE-488 interface for the comput-
er.
• Shielded IEEE-488 cable(s) (Keithley Model 7007).
• MS-DOS or PC-DOS version 3.3 or later.
• Microsoft QuickBASIC version 4.0 or later.
• IOtech Driver488 IEEE-488 bus driver, Rev. 2.3 or lat-
er. (NOTE: recent versions of Driver488 may not sup-
port other manufacturers’ interface cards).
Turbo C program requirements
In order to use the Turbo C programs, you will need the fol-
lowing:
• IBM PC, AT, or compatible computer.
• IOtech Personal488, CEC PC-488, or National Instru-
ments PC-II or IIA IEEE-488 interface for the comput-
er.
• Shielded IEEE-488 cable(s) (Keithley Model 7007).
• MS-DOS or PC-DOS version 3.3 or later.
• Borland Turbo C version 2.0 or later.
• IOtech Driver488 IEEE-488 bus driver, Rev. 2.3 or lat-
er. (NOTE: recent versions of Driver488 may not sup-
port other manufacturers’ interface cards).
Calibration equipment
Table B-1 summarizes recommended comprehensive cali-
bration equipment, and Table B-1 summarizes test equip-
ment required for low-level calibration.

Keithley 2001 Specifications

General

Brand	Keithley
Model	2001
Category	Multimeter
Language	English