Model 2701 Instrument Networking Instruction Manual Introduction 1-5
Status LEDs
Two status LEDs are
located at the top of the RJ-45 connector (Figure 1-1). Refer to
Table 1-1 for a description of LED status descriptions.
Table 1-1
LED status descriptions
LED State Ethernet status
Link/Act Off Network is NOT connected
Link/Act On Network is connected
Link/Act Blinking Traffic is traversing the port
100bT Off 10 Mbit/sec network speed
100bT On 100 Mbit/sec network speed
To Next Page
Loading...
