System Switch/Multimeter User's Manual Section 6:
-900-01 Rev. A / August 2007 6
display.getcursor()
display.getlastkey()
display.gettext()
display.inputvalue()
display.loadmenu.add
display.loadmenu.delete()
display.locallockout
display.menu()
display.prompt()
display.screen
display.sendkey()
display.setcursor()
display.settext()
display.waitkey()
dmm functions
Use the functions and attributes in this group to control DMM operation, set limits, and perform
calibration. Default configuration names like 'dcvolts', 'temperature', 'fourwireohms', etc., imply
the reset conditions for the corresponding function. For example, sending
dmm.setconfig('slot1', 'dcvolts') sets all channels on Slot 1 to use DC volts factory
default settings. To make a channel use one setting that is different, create a user DMM
configuration with dmm.configure.set('mydcv') and then set 'mydcv' to the desired
channels. Available commands:
dmm.adjustment.count
dmm.adjustment.date
dmm.aperture
dmm.autodelay
dmm.autorange
dmm.autozero
dmm.calibration.ac()
To Next Page
Loading...
