18-14 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
[:SOURce[1]]
:CURRent
[:LEVel]
:TRIGgered Set level when triggered: ✓
[:AMPLitude] <n> Specify current level.
1
0 ✓
[:AMPLitude]? Query current level. ✓
:SFACtor <n> Set current scaling factor
(-999.9999e+18 to +999.999e+18).
1.0 ✓
2
:STATe <b> Enable/disable current scaling factor. OFF ✓
2
:STATe? Query current scaling factor state.
:SFACtor? Query current scaling factor.
:STARt <n> Specify start level for I-sweep.
1
0 ✓
:STARt? Query start level for current sweep. ✓
:STOP <n> Specify stop level for I-sweep.
1
0 ✓
:STOP? Query stop level for current sweep. ✓
:STEP <n> Specify step value for I-sweep.
1
0
:STEP? Query step value for voltage sweep.
:SPAN <n> Specify span.
1
0 ✓
:SPAN? Query span. ✓
:CENTer <n> Specify center point.
1
0 ✓
:CENTer? Query center point. ✓
:VOLTage Path to configure V-Source: ✓
:MODE <n> Select V-Source mode (FIXed, SWEep, or
LIST).
FIXed ✓
:MODE? Query V-Source mode. ✓
:RANGe <n>|UP|DOWN| Select fixed V-Source range.
1
21 ✓✓
2
:AUTO <b> Enable or disable autoranging. ON ✓✓
2
:AUTO? Query state of autoranging. ✓
:RANGe? Query V-Source range setting. ✓
1. The parameter values for this command are provided with the detailed command reference information. Detailed information on
SCPI commands follows the last command summary table in this section.
2. If source V is active.
Table 18-7 (continued)
SOURce command summary
Command Description
Default
parameter SCPI
Source
memory
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
