Keithley SourceMeter 2400 Series User Manual

2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-15
[:SOURce[1]]
:VOLTage
[:LEVel] Set V-Source level (in volts): ✓
[:IMMediate] Set specified level immediately: ✓
[:AMPLitude] <n> Specify voltage level.
1
0 ✓✓
3
[:AMPLitude]? Query voltage level. ✓
:TRIGgered Set specified level when triggered: ✓
[:AMPLitude] <n> Specify voltage level.
1
0 ✓
[:AMPLitude]? Query voltage level. ✓
:SFACtor <n> Set voltage scaling factor
(-999.9999e+18 to +999.9999e+18).
0 ✓
3
:STATe <b> Enable/disable voltage scaling factor. OFF ✓
3
:STATe? Query voltage scaling factor state.
:SFACtor? Query voltage scaling factor.
:PROTection Path to limit output voltage: ✓
[:LEVel] <NRf> Specify voltage limit level.
1
(Note 2) ✓
[:LEVel]? Query voltage limit. ✓
:TRIPped? Voltage limit detected: 1 (yes), 0 (no). ✓
:STARt <n> Specify start level for V-sweep.
1
0 ✓
:STARt? Query start level for voltage sweep. ✓
:STOP <n> Specify stop level for V-sweep.
1
0 ✓
:STOP? Query stop level for voltage sweep. ✓
:STEP <n> Specify step value for V-sweep.
1
0
:STEP? Query step value for voltage sweep.
:SPAN <n> Specify span.
1
0 ✓
:SPAN? Query span. ✓
:CENTer <n> Specify center point.
1
0 ✓
:CENTer? Query center point. ✓
:SOAK <NRf> Set first sweep point soak time (0.00000 to
9999.999s).
0.00000 ✓
:SOAK? Query soak time. ✓
1. The parameter values for this command are provided with the detailed command reference information. Detailed information on
SCPI commands follows the last command summary table in this section.
2. SYSTem:PRESet default is 40, *RST default is NONE.
3. If source V is active.
Table 18-7 (continued)
SOURce command summary
Command Description
Default
parameter SCPI
Source
memory
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Keithley SourceMeter 2400 Series Specifications

General

Brand	Keithley
Model	SourceMeter 2400 Series
Category	Measuring Instruments
Language	English