Kemppi Flexlite GX Series User Manual

Flexlite GX
Operating manual - EN
3.7 Adjusting and tightening neck (gas-cooled models)
With the gas-cooled Flexlite GX welding guns (G-models), the neck position can be adjusted.
Tools needed:
24mm
Do not loosen the neck retaining nut more than it is necessary to adjust the neck. Typically the neck retaining nut is
tightened so that the neck is still adjustable by hand, but so that it does not accidentally shift position during weld-
ing.
The Flexlite GX HD models do not have a neck retaining nut. The neck is still adjustable by hand and stays in the
desired position due to its design.
Tighten or loosen the neck retaining nut with a spanner so that it is either possible to adjust the neck position by hand
or tighten the nut so that it secures the neck into the desired welding position.
© Kemppi
31
1921390 / 2310

Kemppi Flexlite GX Series Specifications

General

Brand	Kemppi
Model	Flexlite GX Series
Category	Welding Accessories
Language	English