Flexlite GX
Operating manual - EN
4.1 Using gun remote GXR10 (series 5)
The Flexlite GX series 5 welding gun remote can be used with Kemppi Fastmig equipment only.
Adjust the wire feed speed or change the memory channel by turning the roller switch on the gun handle.
Tip: With the screw in front of the roller switch, under the rubber cap, it is possible to change the wheel's step-
wise responsiveness. Fully stepless adjustment is best suited for adjusting the welding current.
© Kemppi
33
1921390 / 2310
To Next Page
Loading...
