Flexlite GX
Operating manual - EN
3. Cut the wire liner flush with the sleeve nut end. Use a carpet knife for cutting.
4. Install the end cap. Tighten to 1 Nm torque.
3.4.2 Replacing steel wire liner
Tools needed:
Removing and inserting wire liner
This same method applies to both Euro connector (GX series 3 and 5) and Kemppi connector (GX series 8) welding guns, but
the visual details may vary. The method is the same also for both gas- and water-cooled welding guns.
1. Straighten the welding gun cable pack.
© Kemppi
16
1921390 / 2310
To Next Page
Loading...
