Kemppi Flexlite GX Series - Replacing Wire Liner for Multi-Neck

Flexlite GX
Operating manual - EN
5. Install the end cap. Tighten to 1 Nm torque.
3.4.3 Replacing wire liner for multi-neck
With Flexlite GX multi-neck welding guns the wire liner needs to be replaced separately for the neck. For more inform-
ation on wire liner replacement in general, refer to "Replacing steel wire liner" on page16 and "Replacing DL Chili wire
liner" on page12.
1. Remove the neck.
© Kemppi
21
1921390 / 2310