Kemppi KempArc Pulse 350 - 5.10 Power Encoder Potentiometer; 5.11 Arc Length;Voltage;Adjustment Potentiometer; Control Display; Extra Functions Button

EN
5.7 SAVE BUTTON
SAVE
7.
For saving the memory channel.
Short Press: SAVE.
Long Press: Panel is locked. No panel parametre changes allowed (panel lock).
5.8 EXTRA FUNCTIONS BUTTON
8.
Short Press: Crater Filling selection / Hot Start Selection.
5.9 CONTROL DISPLAY
ROBOT
PANEL
CONTROL
9.
ROBOT: Welding parametres taken from the robot
PANEL: Welding parametres taken from the welding machine panel memory channel.
5.10 POWER ENCODER POTENTIOMETER
POWER
10.
The power encoder knob allows adjustment of the wire feed speed or power in either Basic,
Synergic and Pulse MIG/MAG process. Adjustments can be made before or during the arc
process. This control also adjusts additional parametre values when selected.
5.11 ARC LENGTH/VOLTAGE/ADJUSTMENT POTENTIOMETER
U
11.
Arc length, voltage and parametre adjustments can be made using this knob. Adjustments
can be made before or during welding.
22
KempArc Pulse 350, 450 / © Kemppi Oy / 1044