Master M 353, 355
Operating manual - EN
4.1 Daily maintenance
Disconnect the power source from the mains before handling electrical cables.
Welding machine maintenance
Follow these maintenance procedures to maintain the proper functioning of the welding machine:
• Check that all covers and components are intact.
• Check all the cables and connectors. Do not use them if they are damaged and contact service for replacements.
• Check the wire feed rolls and the pressure handle. Clean and lubricate with a small quantity of light machine oil if
needed.
For repairs, contact Kemppi at www.kemppi.com or your dealer.
Welding gun maintenance
For Flexlite GX MIGgun instructions, refer to userdoc.kemppi.com.
© Kemppi
57
1921960 / 2307
To Next Page
Loading...
Need help?
General
