Kemppi Master M 353 - Equipment Description

Master M 353, 355
Operating manual - EN
1.1 Equipment description
Master M device models (350 A)
• Master M 353 G
>> Generator-compatible
>> Standard device with automatic 1-MIG process
• Master M 353 GM
>> Generator-compatible and multi-voltage
>> Standard device with automatic 1-MIG process
• Master M 355 G
>> Generator-compatible
>> Pulse device with automatic 1-MIG and pulse processes. Advanced MAX processes as optional.
• Master M 355 GM
>> Generator-compatible and multi-voltage
>> Pulse device with automatic 1-MIG and pulse processes. Advanced MAX processes as optional.
All Master M device models have a 4-roll wire feed mechanism with the maximum wire spool diameter of 300 mm.
For the Master M device part descriptions, refer to "Master M device" on page8.
Master M control panels
• Color LCD display
Master M cooling units
• Master M Cooler
• Master M Cooler MV (multi-voltage).
For the cooling unit part descriptions, refer to "Master M Cooler cooling unit (optional)" on page11.
MIG welding guns
• Flexlite GX welding guns with euro connector.
For more information on the Flexlite GX welding guns, refer to Kemppi Userdoc.
Welding programs
• Welding program work pack (factory-installed)
• Additional 1-MIG and pulse programs (on-demand / at the time of purchase)
• Additional MAX processes for Master M 355 (on-demand / at the time of purchase).
For more information on acquiring welding programs and additional welding processes, contact your local Kemppi
dealer.
Subfeeders
Subfeeder support can be added with a separate installation kit (contact your Kemppi dealer / service workshop for
more information).
• SuperSnake GTX subfeeder.
For more information on the SuperSnake GTX subfeeder, refer to Kemppi Userdoc.
Optional accessories
• 4-wheel carts
• 2-wheel carts
• Remote control HR40 (2-knob control)
• Remote control HR43 (1-knob control)
© Kemppi
6
1921960 / 2307