Kemppi Master M 353 User Manual

Master M 353, 355
Operating manual - EN
Crater fill
ON/OFF
Default = OFF
When welding with high power, a crater
is usually formed at the end of the weld.
The Crater fill function decreases the
welding power / wire feed speed at the
end of the welding job so that the crater
can be filled using a lower power level.
Crater fill duration, wire feed speed and
voltage are preset by the user. The crater
fill start level cannot be smaller than the
crater fill end level.
When the 4T timer is set to ON, releasing
the trigger during crater fill does not end
welding.
- Crater fill start level
10 ... 150 %, step 1
Default = 100 %
- Crater filltime
0.1 ... 10.0 s, step 0.1
Default = 1.0 s
- Crater fillend level
10 ... 150 %, step 1
Default = 10 %
- Crater fill 4T timer
ON/OFF
Touch Sense Ignition
OFF/ON
Default = OFF
Touch Sense Ignition (TSI) delivers min-
imum spatter and stabilizes the arc imme-
diately after ignition.
WiseFusion
OFF/ON
Default = OFF
The WiseFusion feature enables adaptive
arc length control, which keeps the arc
optimally short and focused. For more
information, refer to "WiseFusion feature"
on page50.
Pulse / DPulse / MAX Position welding parameters (Master M 355 only)
The parameters listed here are available for adjustment with the pulse and MAX Position welding processes in addition to the
MIG and 1-MIG welding parameters. For more information on the processes, refer to "Additional guidance to functions and fea-
tures" on page47.
Parameter Parameter value Description
Pulse current %
-10 … 15 %
Default = 0 %
The pulse current relative to the base cur-
rent in pulse and double pulse welding.
DPulse frequency
0.4 … 8.0 Hz
Default = 2 Hz
These adjust the double pulse frequency
and time percentage.
The pulse ratio adjusts the first pulse
level. When the pulse ratio is set at 35 %,
the ratio of the second pulse level is 65 %.
Note
: The wire feed speed and voltage
fine tuning are adjusted in the main view.
DPulse ratio
10 ... 90 %
Default = 35 %
MAX Position frequency
-0.5 … 0.5 Hz
Default = 0 Hz
This adjusts the MAX Position frequency.
3.3.7 Control panel: System settings
© Kemppi
43
1921960 / 2307

Kemppi Master M 353 Specifications

General

Brand	Kemppi
Model	Master M 353
Category	Welding System
Language	English