Kemppi Master M 353 User Manual

Master M 353, 355
Operating manual - EN
2.2 Installing cooling unit (optional)
The Master M cooling unit must be installed by authorized service personnel.
Tools needed:
1. Remove the small connector cover in the rear of the power source.
2. Route the cooling unit's connection cables so that they remain accessible through the next steps.
3. Lift the Master M device on top of the cooling unit so that the fixing plates align and go into their slots.
Ensure that the cooling unit's connection cables are not caught and/or damaged between the edges.
© Kemppi
14
1921960 / 2307

Kemppi Master M 353 Specifications

General

Brand	Kemppi
Model	Master M 353
Category	Welding System
Language	English