Master M 353, 355
Operating manual - EN
Powerlog trigger logic is not available with manual MIG, DPulse or MAX processes.
Powerlog trigger logic cannot be used together with a remote control. If a Powerlog memory channel is selected
when a remote control is in use, the trigger logic is automatically switched to 4T.
3.4.7 WiseFusion feature
Available in Master M 355 only.
The WiseFusion feature enables adaptive arc length control, which keeps the arc optimally short and focused. WiseFu-
sion increases the welding speed and penetration and decreases heat input. WiseFusion can be used throughout the
power range (short arc, globular arc and spray arc). WiseFusion is compatible with 1-MIG, MAX Position and pulsed MIG
welding processes.
>> To take WiseFusion into use, go to the control panel's Welding parameters view and apply the WiseFusion fea-
ture.
>> To adjust the wire feed speed, in the control panel's Main view, turn the left control knob.
>> To fine tune the heat output while welding, in the control panel's Main view, turn the right control knob.
For more information on Wise products, visit www.kemppi.com.
3.4.8 WeldEye with DCM (optional)
Kemppi's WeldEye welding management software is also available for use with Master M. For this, an additional Digital
Connectivity Module (DCM) device is required. DCM is connected directly to the Master M's control connection with the
cables and adapters delivered with the DCM device.
For more information on installing and using the DCM device, refer to userdoc.kemppi.com (DCM/WeldEye).
Discover WeldEye – universal welding management software
WeldEye is your primary tool and storage space for keeping your welding-related documents in order. WeldEye is a uni-
versal solution for managing welding production.
WeldEye's modular structure is based on various useful functions that serve the needs of wide-ranging industries and
welding-related tasks:
• Welding procedures
© Kemppi
50
1921960 / 2307
To Next Page
Loading...
Need help?
General
