MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
2. Move the power source on top of the cooling unit so that the bar in the rear goes into the rear connection
interface and lower the front onto the front connection interface. Secure the power source from the front with
the screws provided.
Ensure that the cooling unit’s connection cables don't get caught between the units and get damaged in the process.
3. Connect the cooling unit cables and put the rear cover back.
4. Fill the cooling unit with cooling liquid.
>> MasterTig Cooler M tank volume is 3 litres and the recommended coolant is MPG 4456 (Kemppi mixture).
Avoid cooling liquid contact with skin or eyes. In case of an injury, seek for medical advice.
© Kemppi
11/77 1920900 / 1939
To Next Page
Loading...
