MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
2.12 Moving equipment by lifting
If you need to lift MasterTig welding equipment, pay special attention to the safety measures. Also follow the local
regulations. MasterTig welding equipment can be lifted with a mechanical hoist when the equipment is installed
securely on the cart.
If a gas bottle is installed on cart, DO NOT attempt to lift the cart with the gas bottle in place.
DO NOT attempt to lift the equipment with a hoist from the handle.
4 wheel cart (P45MT):
1. Ensure that the welding equipment is properly secured to the cart.
2. Connect the 4-legged chain or straps from the hoist hook to the four lifting points on the cart on both sides of
the welding equipment.
© Kemppi
23/77 1920900 / 1939
To Next Page
Loading...
Need help?
General
