MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
2. Secure the control panel together with the hinged panel cover in place with the screw provided.
The hinged panel cover and the control panel are secured with the same screw.
2.3 Installing cooling unit
Only an authorized electrician is allowed to install the cooling unit.
Do not connect the equipment to the mains before the installation is complete.
Do not attempt to move the power source with a hoist from its handle. The handle is meant for manual lifting only.
When a transport cart is used, refer also to the "Mounting units on cart (optional)" on page13 chapter.
Tools:
• Screwdriver, Torx head (T20).
1. Remove the power source's rear cover.
© Kemppi
10/77 1920900 / 1939
To Next Page
Loading...
Need help?
General
