MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
Service workshops
Kemppi Service Workshops complete the welding system maintenance according to the Kemppi service agreement.
The main aspects in the service workshop maintenance procedure are:
• Cleanup of the machine
• Maintenance of the welding tools
• Checkup of the connectors and switches
• Checkup of all electric connections
• Checkup of the power source mains cable and plug
• Repair of defective parts and replacement of defective components
• Maintenance test
• Test and calibration of operation and performance values when needed.
Find your closest service workshop at Kemppi website.
4.1 Disposal
Do not dispose of any electrical equipment with normal waste!
In observance of WEEE Directive 2012/19/EU on waste of electrical and electronic equipment and European Directive
2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment, and
their implementation in accordance with national law, electrical equipment that has reached the end of its life must
be collected separately and taken to an appropriate environmentally responsible recycling facility. The owner of the
equipment is obliged to deliver a decommissioned unit to a regional collection center, as per the instructions of
local authorities or a Kemppi representative. By applying these European Directives you improve the environment
and human health.
© Kemppi
55/77 1920900 / 1939
To Next Page
Loading...
Need help?
General
