MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
Weld Assist automatically sets the following parameters for you:
• Current mode: AC / DC-
• Current: 3...300A or 3...230A depending on the machine used
• Pulse (if used): Frequency
• AC and Start & stop parameters: Set to default.
All these parameters can still be modified as per normal for the actual welding.
Weld Assist gives you a recommendation for these:
• Shielding gas flow: "Argon" + l/min and "Helium" + l/min
• Electrode: Diameter
• Filler (if used): Material and diameter
• Number of passes: Number and/or visualization
• Travel speed: mm/min.
© Kemppi
39/77 1920900 / 1939
To Next Page
Loading...
