MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
Downslope: OFF / 0.1 s ... 15.0 s (Default = 0.1 s)
Tail arc: OFF / 5 % ... 90 % (Default = OFF)
Post gas: 0.1 s ... 30.0 s / AUTO, 0.1 s step.
Adjustable parameters in spot welding:
Pre gas: 0.0 s ... 10.0 s, Auto, 0.1 s step (Default = Auto)
Upslope: OFF / 0.1 s ... 5.0 s, 0.1 s step (Default = 0.0 s)
Spot time: 0.0 s … 10.0 s, step 0.1 s (Default = 2.0 s)
Downslope: OFF / 0.1 s ... 15.0 s (Default = 0.1 s)
Post gas: 0.1 s ... 30.0 s / AUTO, 0.1 s step (Default = Auto).
Adjustable parameters in MicroTack welding:
Pre gas: 0.0 s ... 10.0 s, Auto, 0.1 s step (Default = Auto)
MicroTack spot time: 1 ms ... 200 ms, step 1 ms (Default =10 ms)
MicroTack pause time: 50 ms ... 500 ms, step 1 ms (Default = 50 ms)
>> This is not visible in the settings if the MicroTack pulse count is only 1.
MicroTack spot count: 1 ... 5 / endless, step 1 (Default = 1)
>> If Lift TIG is used, MicroTack graph shows only 1 spot and the spot count parameter is not visible.
Post gas: 0.1 s ... 30.0 s / AUTO, 0.1 s step (Default = Auto).
"Welding processes and features" on page67
© Kemppi
42/77 1920900 / 1939
To Next Page
Loading...
Need help?
General
