MasterTig 235ACDC, 325DC, 335ACDC
Operating manual - EN
40 VRD error
Open circuit voltage exceeds the VRD limit. Restart the power source. If problem persists, contact
Kemppi service.
80 Torch cooling
required
Water cooled torch is connected but the
cooler is turned off.
Turn the cooler on in the settings menu or change the
torch to an air cooled model.
81 Welding pro-
gram data
missing
Welding program data has been lost. Restart the power source. If problem persists, contact
Kemppi service.
244 Internal
memory fail-
ure
Initialization failed. Restart welding system. If problem persists, contact
Kemppi service.
250 Internal
memory fail-
ure
Memory communication failed. Restart welding system. If problem persists, contact
Kemppi service.
© Kemppi
58/77 1920900 / 1939
To Next Page
Loading...
Need help?
General
