oInserting the bobbin
q_ End of thread
(_ Notch
('_)Notch
@_Threading diagram
I.TjPlace a bobbin in the bobbin holder with the thread
running off counterclockwise,
[_ Guide the thread into the notch (_j)on the front side of
the bobbin holder,
Draw the thread to the left, sliding it between the tension
spring blades
_j Continue to draw the thread lightly until the thread slips
into notch t_, Pull out about 6" (15 0 cm) of thread
[_ Attach the hook cover plate, Check the threading by
referring to the diagram _jt shown on the hook cover plate
f
iZi
13
%
/
,,
t5
To Next Page