KENT Razor 20 - Vacuum System Motor Disassembly;Assembly

RECOVERY WATER SYSTEM
SERVICE MANUAL
ENGLISH
Razor™ 20 / 20T 9097065000(2)2009-06
25
VACUUM SYSTEM MOTOR DISASSEMBLY/ASSEMBLY
Disassembly
If the tank (21) contains recovery water:1.
Drive the machine to the appointed recovery water disposal area.

(For Razor™ 20) Turn off the switches (71) and (73).
Empty the recovery water tank (21) with the hose (16).
2.
 3.
(For Razor) Turn off the switches (71) and (73).
Disconnect the battery connector (12).4.
Grasp the handle (41) and carefully lift the tank (40).5.
Remove the screws (A) and recover the washers.6.
Remove the motor cover (B).7.
8.
Remove the motor (E), the sound-deadening pipe (F) and the sound-deadening panel (G).9.
Disconnect the electrical connector (H) of the motor (E).10.
11.
Assembly
Assemble the components in the reverse order of disassembly, and note the following:12.

L
K
J
I
E
H
G
F
A
A
B
C
D
L
S301556